Page 1 of 1
Did you know...
Posted: 26 Feb 2010, 02:42
by Meat Engine
...that the nominal dish volume, taken to the tenth of a gallon, of an ASME 2:1 elliptical head with an inside diameter of 60" is approximately ten times the volume of 1" of straight side on a shell can with the equivalent inside diameter? Is this interesting? Not at all. Am I bored? Just a bit.
Re: Did you know...
Posted: 26 Feb 2010, 02:46
by Mr. P
Nope. And how do you think I can now use this information in my daily life?
Re: Did you know...
Posted: 26 Feb 2010, 02:51
by Hugo.
It's Fu's attempt at xkcd-style humor.
Re: Did you know...
Posted: 26 Feb 2010, 03:02
by Meat Engine
[quote name="Pentelesh"]Nope. And how do you think I can now use this information in my daily life?[/quote]
Perhaps it could be your opening line to a lady petroleum engineer. It might get her all hot. I don't know.
Re: Did you know...
Posted: 26 Feb 2010, 03:04
by Redd
This sounds like math. Math

Re: Did you know...
Posted: 26 Feb 2010, 04:04
by Hugo.
Shouldnt you be singing in highschool musical or something?
Re: Did you know...
Posted: 26 Feb 2010, 05:09
by djonni greazo
[quote name="Redd"]This sounds like math. Math

[/quote]

Re: Did you know...
Posted: 26 Feb 2010, 05:34
by Haunty
I"m glad epic fail has an official seal now. :neat:
Re: Did you know...
Posted: 26 Feb 2010, 05:39
by User
1011010010101
Re: Did you know...
Posted: 26 Feb 2010, 05:44
by Lavabug
SI units please.
Re: Did you know...
Posted: 26 Feb 2010, 08:32
by Meat Engine
I like SI, but the American petroleum industries do not. They're particularly sadistic with measurements like barrels per foot of pipe.
Re: Did you know...
Posted: 26 Feb 2010, 16:38
by Lavabug
[quote name="The Fu Monster"]I like SI, but the American petroleum industries do not. They're particularly sadistic with measurements like barrels per foot of pipe.[/quote]
Don't barrels have a standardized capacity? Probably a whole number in liters or m^3.
Re: Did you know...
Posted: 26 Feb 2010, 18:12
by Abzu
Maybe it would have been better if it were accompanied by a stick figure cartoon.
Re: Did you know...
Posted: 26 Feb 2010, 20:03
by Meat Engine
[quote name="Lavabug"]
[quote name="The Fu Monster"]I like SI, but the American petroleum industries do not. They're particularly sadistic with measurements like barrels per foot of pipe.[/quote]
Don't barrels have a standardized capacity? Probably a whole number in liters or m^3.[/quote]
42 gallons. Rockefeller didn't want people to think they were getting cheated on a 40 gallon barrel of oil. I love SI units for just about everything except pressure. Having 101.3 kPa be atmospheric pressure is just MEH. That's still not as bad as inches of mercury or inches of water, though.
I am so glad that I don't have to do any calculations involving slugs.
